Specifications include, but are not limited to: 2.01 TAPPING SLEEVES A. Material 1. Sleeve Body and Branch a. Stainless Steel grade 304 or 316 per ASTM A240 b. Branch shall be a one-piece casting of 304 or 316 stainless steel welded 360 degrees to the sleeve body. 2. Branch and Sleeve Gasket a. EPDM, SBR, NBR Rubber – non- recycled b. NSF 61 Approved c. No adhesives B. Performance Criteria 1. Branch/Watermain Diameter 4-inch to 8-inch Dia. a. Two-piece sleeve body b. Working Pressure – 250 psi c. Test Pressure – 300 psi d. Sleeves shall be adaptable to properly fit and seal Class A, B, C, D Pit Cast Gray Iron pipe and Ductile Iron Pipe 2. Branch/Watermain Diameter 10-inch to 24-inch Dia. a. Two-piece sleeve body b. Working Pressure – 200 psi c. Test Pressure – 300 psi. d. Sleeves shall be adaptable to properly fit and seal Class A, B, C, D Pit Cast Gray Iron pipe and Ductile Iron Pipe. 3. Watermain Diameter 30-inch to 36-inch Dia. a. Three-piece sleeve body b. Working Pressure – 100 psi c. Test Pressure – 150 psi. d. Sleeves shall be adaptable to properly fit and seal Class A, B, C, D Pit Cast Gray Iron pipe and Ductile Iron Pipe C. Fasteners 1. Stainless steel 304 or 316 drop-in track-head bolts and stainless steel heavy hex nuts with fusion bonded coating. 2. Fasteners and hardware including bolts, hex nuts, and washers shall be furnished with the tapping sleeve in the amount/quantity necessary and size necessary to complete the installation and attain performance requirements outlined herein. 2.02 REPAIR SLEEVES (4” – 12” Diameter) A. Material 1. Sleeve body and appurtenances shall be fabricated completely from Stainless Steel grade 304 or 316. 2. Sleeve Gasket a. NSF 61 Approved b. Virgin NBR, SBR or EPDM Rubber c. Minimum ¼ inch thick circumferential gasket d. No adhesives between gasket and sleeve body. 3. Performance Criteria a. One piece, two panel sleeve body b. Minimum Working Pressure – 150 psi c. Sleeves shall be adaptable to properly fit and seal Class A, B, C, D Pit Cast Gray Iron pipe and Ductile Iron Pipe. 4. Fasteners a. Welded on stud bolts – Stainless Steel with passivated welds. b. Hardware shall be furnished with the repair sleeve in the amount/quantity necessary and size necessary to complete the installation and attain performance requirements outlined herein. 5. Approved Manufacturers a. Power Seal b. Approved Equivalent