• Install the Axis Q1805-LE camera on the building as indicated. • Run CAT6 cable between the county switches and the installed Axis cameras. • Install the purchased TM400 enclosure in the site’s mechanical room as indicated • Install the purchased LNL-X2220 and Altronix power supply in the mounted TM400 enclosure. • Install one of the purchased HID Signo 20 card reader on the main entrance as indicated. • Install a purchased HID Signo 20 card reader on the side door as indicated. • Install the purchased Alarm Control monitor and control station near the keypad. • Install the GRI door contact on the two card reader doors. • Wire the Altronix power supply to power the LNL-X2220 reader board. • Install any surface mounted conduit to conceal wires in the building. Conduit is needed only where wires would otherwise be visible in normal building use (i.e. conduit is not needed if wire is being run through the ceiling) • Wire the installed door contact, QEL, control station, and card readers to the Lenel access panel. o The door contact will be wired to the intrusion panel and the card access system. o Crashbars have built in REX device • Program the 2 installed card readers into the County’s OnGuard 8.2 card access software. • Program the first badge read of the card access system to disable the Bosch Intrusion system. • Program the Alarm Control DPDT control station to change the reader mode of the main entry reader and side entry reader in OnGuard 8.2
