Specifications include, but are not limited to:The purpose of the Solicitation is to contract with a vendor(s) to provide Salt Brine Production Systems, Shelters, and Pumping Stations (S-829) which may be purchased by State Agencies and Cooperative Purchasing Venture (CPV) members on an as needed basis. REQUIREMENTS FOR SALT BRINE PRODUCTION SYSTEMS 1.1 Brine tank minimum holding capacity shall be 500 gallons. 1.2 Main salt brine tank shall be constructed from stainless steel; rotationally molded polyethylene that is UV stabilized to provide protection from sunlight or made of fiberglass with a ceramic coating. 1.3 Brine tank shall have an open floor with no interior ribs to hinder cleaning. Tank shall have a pitched bottom to the lower sump area or a hinged sump to provide total drainage. 1.4 Hopper/rock salt tank shall be constructed from stainless steel, rotationally molded polyethylene that is UV stabilized to provide protection from sunlight or made of fiberglass with a ceramic coating. 1.5 Hopper shall have an open floor with no interior ribs to hinder cleaning. Hopper shall have a pitched bottom to lower sump area or a hinged sump to provide total drainage. 1.6 Hopper shall have a full-length water in-feed manifold to provide even filling and salt saturation. 1.7 Minimum rock salt holding capacity shall be 3 cubic yards. 1.8 Discharge shall be controlled by a 25' remote waterproof toggle switch. 1.9 Effluent ejector pump shall be UL listed and have thermal overload protection. 1.10 Unit shall have a minimum #20 mesh monel screen for the intake. 1.11 Water service piping shall be 1-1/2" minimum throughout the entire system. Water in-feed to the hopper tank shall be controlled to maintain the level of brine in the main tank. 1.12 Water in-feed and salinity dilution shall be controlled by ball valves. 1.13 Unit shall be supplied with 1-1/2" glass filled polypropylene quick disconnect cam lock coupling from pump discharge. 1.14 Installation of the salt brine production systems is accomplished by connection of the threaded male end of the water in-feed piping to customer supplied water service. 1.15 Secondary containment system shall be constructed from stainless steel or rotationally molded polyethylene that is UV stabilized to provide protection from sunlight. 1.16 Secondary containment system shall be equipped with a minimum of one drain fitting. 1.17 Secondary containment system shall have a minimum containment capacity of 110% of the combined brine tank and hopper tank capacity
