A. Specifications for Resurfacing, Repairs, and Striping • Strip all courts with a high-water pressure procedure. • Surface should be free of all loose material, dirt, oil, mildew and treated with an outdoor bleach. • All cracks 1/16” and up that do not exceed 3/8” shall be cleaned, weed killer applied and filled. • All cracks 3/8” or wider shall be routed and filled. • Any larger crack area requiring the use of “Armor Crack Repair” product, or equivalent, should be noted in the response and the quote. • All crack filler should be poured continuously until flush with existing surface. • Drill and fill all iron oxide pop-outs and blisters. • Crack filling product should be Elite Systems, Amsco Inc., Patch Binder or approved equivalent. • All repaired cracks must be finished flush to adjacent surfaces. • Entire surface must be checked for low areas, poor drainage and any other irregularities by flooding with water and allowed to drain for one hour. • Surface must be tolerance, so no depressions exceed 1/16” along a 10’straight edge. • All depressions holding water deeper then 1/16” shall be patched and leveled in accordance with recommendations of the manufacturer of the color finishing product. • All depressions must be repaired utilizing a plexi-binder acrylic surface system or approved equivalent sand filled emulsion mix.
