Specifications include, but are not limited to: Wausau SNOGO Model MP Rotary snow Blower 1.0 Base Specifications: 1.1 Unit to have equipment numbers 57-0683 Bead welded in 2" high numbers in a conspicuous location. 1.2 The complete paint film, to include primer and finish coat, shall have a minimum thickness of 2.5 mils 1.3 "All wires passing through holes in metal or non-metal wearing surfaces, which could cause wear of the insulation, shall be adequately protected by rubber or plastic grommets, and/or non-metal conduit. Ends of all wires shall be adequately anchored to prevent loosening. All wiring shall be properly secured to the unit by proper wiring hangers. " 1.4 Ends of all wires shall be adequately anchored to prevent loosening 1.5 All electrical connections shall be soldered and enclosed in heat shrink or in water tight junction blocks 1.6 Scotch locks and wire nuts are not acceptable 1.7 Any non-factory wiring harness shall be made with weather pack connectors 1.8 All hydraulic lines shall be adequately protected and shall be properly secured to the unit by proper hose clamps 2.0 General Data: 2.1 Operating Capacity: 1800 -2000 tons per hour 2.2 Snow Casting Distance: up to 150 feet 2.3 Weight of Complete Unit: 9800 pounds 2.4 Unit shall be completely self-contained, two-stage design 2.5 Bolt on-hitch, ACS Female Blank Pro 2000 series to fit 2012 John Deere 624K loader 3.0 Dimensional Specifications: 3.1 Cutting Width 114 inches 3.2 Cutting Height 58 inches 3.3 Box Height 52 inches 3.4 Height to Top of Chute (retracted) 128 inches 3.5 Height to tipper (chute up - tip up) 148 inches 3.6 Front to Back Dimension 97 inches 3.7 Height: Ground to Top of Back Frame 42 inches