Specifications include, but are not limited to: Gear Dryer Specifications The dryer unit shall be designed for heavy-duty commercial use. It shall have a minimum capacity of no less than six (6) sets of gear that can be dried at one time. Drying temperature shall not exceed 105-degrees F. It shall have a minimum heating capacity of six thousand (6,000) watts and a minimum airflow of no less than nine hundred (900) cubic feet per minute. The exhaust shall be no less than twelve (12) inches in diameter and the exhaust fan shall be provided with a temperature sensor. The unit shall be provided with four (4) removable open grate shelves, six (6) removable gear hangars and six (6) removable glove hangars. ꞏ Power shall be 208/240 volt, single phase, with 35AMP protection. ꞏ Model shall be a Circul-Air E6XX express dryer 240 Single Phase ꞏ Or approved equal. Bidder shall provide complete information on the unit proposed in the bid package, including product literature, warranty and installation information. Washer/Extractor Specifications The washer/extractor unit shall be designed for heavy-duty commercial use. It shall have a minimum capacity of no less than 30-pounds, have a minimum capacity of 4.4 cubic feet and shall be designed to launder four (4) sets of gear at once. The washing speed shall be 48-RPM. It shall have a variable spin cycle that provides a minimum of six (6) spin speeds, none of which shall exceed the NFPA recommended 1,000 RPM. The maximum G-force shall be no less than 346 to better extract moisture. Inner and outer drums shall be fabricated of 304-stainless steel. ꞏ Power shall be 208/240 volt, single phase, with 15-AMP protection. ꞏ The drain diameter shall be a minimum of three (3) inches and two (2), ¾” inlets shall be provided. ꞏ An automatic detergent injection system shall be provided with the completed unit. Model shall be Unimac model UCT030QN0G ꞏ Or approved equivalent. Bidder shall provide complete information on the unit proposed in the bid package including product literature, warranty and installation information. Installation The bidder shall provide turnkey delivery, installation and training on each machine. Bidder shall provide a base for the unit and the design shall be such that it does not need to be fastened to the floor.