Custom Marching Band Trailer for L’Anse Creuse High School Trailer 2025 Tandem Axle Kentucky Electronics Van or similar 53’ Length with Interior Volume of 4,200 Cubic Feet 13’ 6” Trailer Height Model FVCC-D or similar 4 doors curb-side and 2 doors street side 3 Belly boxes forward of the axles, 1 Belly box behind the axles Rear swing doors Nose deck floor 11.5’ Main deck floor 41.5’ Floor 1 5/16” laminated oak with 2 coats clear polyurethane Customization Prepare trailer exterior for new paint by scuffing the entire exterior, and the removal of all holdbacks and latches Single color painting of exterior, (no pearl or metallic) paint color to be chosen to compliment the graphic Holdbacks (wind latches) for exterior doors and belly boxes reinstalled or replaced as necessary DOT conspicuity tape 50% coverage Graphics Graphics to be printed and installed from files created in concert with collaboration from the district Graphics template will be finalized based on the dimensions of the sourced trailer Vinyl all 4 sides Full-color digitally printed graphics on 3M™ vinyl with an MCS™ warranty Film topcoat for durability and UV resistance to color fade Access Power retracting stairs from the ground to the nose deck in the #1 curb-side door – All aluminum construction A set of 3 lightweight aluminum ramps with heavy-duty trailer end approach plates and toolless/pinless mid-support stands Each ramp to be 22.5” wide and 14’ long and with mid-support stands. Each ramp shall be able to support 1,000 pounds with the mid-support stands in-place Buildout Second floor above the main deck. Upper deck to be 28 feet long and begin at the nose deck step with a split stair Industry standard load bars and ¾” plywood decking High durability commercial carpet on the second floor Custom door spans to allow all door openings to be fully functional Floor-to-floor dimension to be 45” with 41 ½ “clear below the second floor Fixed stairs from the nose deck to the second floor Powered retracting stairs from the main floor to the upper deck at the tail-end of the upper deck floor – All aluminum construction 52” door bars installed on every open doorway from the second floor Instrument Shelves Three sections of 6-foot instrument shelves Each shelf will be beveled back to the wall 5 degrees and covered in an open loop carpet Each individual 6’ shelf can accommodate a combination of 5 baritones or mellophones in cases Drum Wall Shelves for cased battery percussion to accommodate a up to a 10-6-5 instrumentation Each shelf will be beveled back to the wall 5 degrees and covered in an open loop carpet Installation of the “Carrier Carrier” from the ceiling of the nose deck, will accommodate 24 drum carriers Guard Drawers A pair of eight foot wide by 4 foot deep on full extension drawer slides Installed in the street side belly boxes
