Specifications include, but are not limited to: Van Body Remove existing 14' aluminum van body, 5" extension, double bumper and mud flaps from cutaway chassis Include credit for primary bidder to take possession of van body, 5" extension and double bumper. Provide credit in offered column. Disconnect back -up camera and hold for re -installment Hold mud flaps for re -installment Utility Body Provide a New Cutaway Utility Body Utility body is to seal to existing cab with recessed bulkhead for seat clearance 156" Body Length Solid bulkhead (no walk -through door acceptable) Overall lower body width: 94" minimum Load area width to be a minimum 54" wide due to required usage Entire body to be fabricated from A60 Galvanneal steel Five (5) cabinets per side at minimum 40" height Lockable stainless steel paddle latches for all compartment doors and one (1) lockable stainless steel paddle latch for rear doors - all locks keyed alike All vertical doors to have gas shock retainers 15" deep lower compartments minimum Neoprene automotive rubber seals around all compartments door jams Minimum 1/4" stainless steel hinge pins on compartment doors for durability and corrosion protection Hinges to be bolted to body – no welding or tack -welding of hinges to body acceptable 12 gauge treadplate steel load area floor (punched floor not acceptable) Flush -mounted compartment doors – doors are to recess completely into door frame for maximum leakage protection Furnish & Install Spray -On Bedliner. Applied to: Load Area Floor, Load Area Lower Sides, Load Area Side of Bulkhead to Height of Lower Sides . Compartment doors construction to be formed and bonded - no welds accepted so as to eliminate warping Street side front compartment to be vented Shelving package to consist of two (2) trays with divider slots in both