Specifications include, but are not limited to: 1) LUBRICATING OIL SYSTEM - Sample and inspect oil. Upon request, run a spectrum analysis of old oil and report finding. Replace oil and filter annually. Add oil as necessary. Ensure oil heater is functional (if equipped). Correct leaks and make adjustments as necessary. 2) COOLANT SYSTEM - Inspect sample of coolant and change if necessary. Add coolant to maximum level. Ensure that all generators in unheated locations are protected to at a minimum - 25 degrees F., correct leaks and make necessary adjustments. 3) FUEL SYSTEMS - Inspect accessible fuel system including carburetor (if applicable), fuel injectors, regulating valves, lines, filters, bowls, and all connections for evidence of water or failure. Annual fuel filter replacement. Make necessary adjustments and minor repairs. Verify that storage tank, if installed is a minimum 2/3 full and ensure fuel quality of tank. Test lines for sludge and/or water and flush if required. 4) BELTS AND HOSES - Inspect belts and hoses for tension and integrity. Adjust and/or replace as necessary. Standing block heater discharge/inlet hoses must be replaced with high temperature silicon hoses at no additional cost to the County.