Specifications include, but are not limited to: a) Perform necessary rigging and staging to haul vessel. b) Inspect bottom and hull for defects, excessive corrosion, and/or problems. c) Inspect all fenders and bumpers for damage and/or presence. d) Clean and prepare bottom for paint; From Deck down, sand all bare areas to bare metal and prime as necessary. e) Paint entire bottom from deck down, using a quality marine type paint, use anti-fouling paint below water line. f) Inspect, clean, lubricate and adjust all thru-hull fittings and sea cocks. g) Inspect, Clean, and Check heat exchangers. h) Confirm proper operation of all bilge pumps. i) Replace all zincs as needed. j) Inspect propellers, shafts, shaft stuffing boxes and cutlass bearings. k) Inspect engines, transmissions, steering, generator and all controls for proper function and operation. l) Prepare Marine Condition and Compliance Survey. m) Any deficiencies or recommendations for additional work shall be reported to the MDOT MPA Fleet Manager at 410-633-1052. A written estimate for any additional work shall be submitted to the MDOT MPA for review and approval. No additional work shall be performed unless approved by the MDOT MPA. The allowance for any additional work approved by the MDOT MPA is $15,000 (see Bid Form Item No.3).