Specifications include, but are not limited to: 2020 or current model in production. Frame material: 120,000 psi steel minimum, main rail to be 3,350,000 FEM. single Swept back front bumper. 2 frame mounted tow hooks. GVWR35,000 lbs. maximum. Painted black. Front Axle: 12,000-lbs Capacity "I" beam axle. Set forward. Oil bath front wheel seals & front shock absorbers. Rear Axle: Minimum 23,000 lbs capacity single speed. Rear springs minimum 23,000-lbs capacity. Transmission: Allison 6-speed automatic, 3000 RDS with dash mounted push button controls. Synthetic transmission fluid. PTO: A Muncie PTO and direct-mount pump sufficient to properly operate the specified crane. The PTO switch is to be supplied by the vehicle manufacturer and wired by the crane installer without any holes drilled into the dash under any circumstances. Crane shall operate via direct mount fixed displacement piston pump. Driveline: Drive shaft with coated split joint splines. ; Wheels: One piece steel wheels. Powder coated white. Tires: Front: 11R 22.5 16 ply FS 560. Rear: 11R 22.5 16 ply M/S rated. Goodyear Radial tires. Proper size mud flaps. Brakes: Dual air brake system with ABS. Outboard mounted brake drums front and rear. 13.2 CFM Bendix air compressor. ; Engine: Diesel, four cycle turbo charged, after cooled, with 350 gross HP and 860 gross torque. Viscous fan drive Automatic engine shutdown for low oil pressure and high water temp. With electronic override. Magnetic oil drain plug. Water cooling filter, must be spin type with shut-off valve. Electronic hand throttle. Engine hour meter. ; Gauges: Full gauge cluster, illuminated, including speedometer, tachometer, fuel, water temperature, oil pressure, volt meter. Paint and Finish: Cab exterior painted DuPont Armour Yellow 93-3421 Electrical System: 12 volt system with automatic or manual reset circuit breakers. 160 amp alternator. Data link connector for vehicle programming and diagnostics. Factory up fitter switches, Six.