Specifications include, but are not limited to: 3.2.1.1 The airboat shall be fully operational upon acceptance. 3.2.1.2 The airboat shall conform to all federal, state, and marine safety regulations. 3.2.1.3 The airboat shall be constructed in accordance with or exceed industry standards for this type of vessel. 3.2.2.1 Marine Grade 5086 Aluminum Alloy 3.2.2.2 Hull shall be 20ꞌ long with an 8ꞌ beam – V-crimped sides 3.2.2.3 Hull bottom to be one piece with no splicing Hat and Pocket Clip Badge 3.2.2.4 C30" Sides and 28" Transom at Center Height 3.2.2.5 8 degree bottom 3.2.2.6 Hull bottom: .250 5086 Marine Grade Aluminum – 8 degree bottom 3.2.2.7 Transom: .250 5086 Marine Grade Aluminum 3.2.2.8 Bulkhead: .190 5086 Marine Grade Aluminum 3.2.2.9 Sides: .190 5086 Marine Grade Aluminum 3.2.2.10 1/2" UHMW black polymer nut & bolted on bottom of hull - POLYMER APPLIED TO FULL BOTTOM OF HULL 3.2.2.11 3/8" UHMW Black screwed on sides of hull – 8" 3.2.2.12 9 - 2" x 2" x 3/8" Aluminum T-bar stringers w/every other T-Bar doubled 3.2.2.13 .190 Aluminum Gussets on every T-Bar at Transom 3.2.2.14 .190 Aluminum Gussets under transom splash plate 3.2.2.15 3 – 3" Aluminum I-Beam Cross Braces 3.2.2.16 There shall be a 38" flat non-skidded aluminum deck 3.2.2.17 14" x 28" recessed aluminum deck lid w/stainless steel lock and hydraulic 3.2.2.18 Two 1" drain plugs 3.2.2.19 Stainless steel bow eye 3.2.2.20 Full Walk-arounds enclosed with two doors on each side large enough to accommodate (back boards) and two small doors at rear of walk arounds (drawings to be provide for approval. Doors on passenger’s side to have dividers to accommodate back-boards 17" x 73" with a 4: Gap) 3.2.2.21 Recessed deck lid in front of passenger seating (fabricate door as large as possible) 3.2.2.22 Four stainless steel pull up cleats – one on each corner gusset 3.2.2.23 Weld .190 Plate Inside of Boat on Bottom Side from transom to Bulkhead 3.2.2.24 Re-enforced hull with four additional – 2" x 2" x 3/8" Aluminum T-Bars to center section on side of hull from transom to first and second cross brace, attaching bracing from floor of hull over to sides with two attachment points on the side 3.2.2.25 Covered nose roll – 3.2.2.26 High efficiency hydraulic Ice Brake