Specifications include, but are not limited to: Contractor will remove the existing heat pumps and install two (2) replacement heat pumps. The systems currently rate at two and one‐half 2.5) tons unit with a 12 kW electric reheat. These systems will be replaced with new heat pumps and reheats (base of design Trane XR15I Series 4TWX5030B1 & TAM4A0A30S21 with 10 kW electric reheat. This will include at a minimum: ● the outdoor unit shall sit on an equipment pad located on the roof ● line set between outside and indoor section will be ran reusing the existing penetrations ● install replacement heat pump systems including: ● anti‐recycle timer ● evaporator defrost control ● new refrigerant line sets ● electrical and condensate drainage to the available access point ● 208 Volts, 1 phase ● condensate will be tied into the existing ● the outside air make up will be reconnected to the existing ● duct work ● will be reconnected to the existing ● the contractor will provide material and labor for any duct work alterations needed to reconnect the new system to the existing ductwork ● other tasks and materials germane to the installation.