Specifications include, but are not limited to: -axle dimension shall not be less than 96 inches. The frame shall be of sturdy construction and shall have a section modulus of not less than 17 inches, 120,000 PSI, including reinforcement which must be C type exclusive of fishplates, to carry its maximum rated gross load, plus an overload of 15% of the rated payload without evidence of sagging or distortion. Frame shall have intregal extension so that the bumper is ahead of the normal position by a minimum of 12 inches to allow mounting of a front hydraulic pump. The bumper must not be less than 6 inches ahead of the grill in order to carry snowplow. Bumper shall be steel, 9 minimum depth with 2 flange. cab shall be of all steel/aluminum construction with fiberglass hood and fenders and equipped with shatterproof glass properly sealed to eliminate all water leaks. The cab is to be painted white. Cab and Frame shall have a minimum warranty of 5 years with unlimited mileage. Cab equipment shall have (2) two doors, entirely constructed by the original equipment manufacturer, with air ride (National 2000 Air Suspension High Back Vinyl) driver seat and non-suspension passenger seat. All seats to have heavy-duty vinyl covering. Other equipment required will include but is not limited to the following: - A total of two S.A.E. approved seatbelts - Roof drip molding - Right and left heated 7X16# West Coast mirrors with integral convex mirror - Cab grab handles at both doors - Door activated dome light - Dual sun visors - Electronic hand throttle - Windshield washers - Electric windshield wipers with intermittent feature - Vinyl floor mat, full width of cab - Headliner - Fresh air heater and defroster - Air conditioner - Ammeter/voltmeter - Fuel level gauge - Water temperature gauge - Oil pressure gauge - Transmission oil gauge - Gauges to have visual and audible warnings for low fuel, low oil pressure, high engine temperature and low battery voltage - Tachometer - Hour meter - Speedometer/odometer combination - AM/FM radio