Specifications include, but are not limited to: The successful bidder will check the following items monthly (but is not limited to this list) and if conditions warrant repair or replace. These items covered are as a result of normal wear and tear. Hoisting machine components, including traction driver, bearings, worm and ring gear and seals; Brake, including coil, pivot pins and linings; Major rotating equipment, including the hoist motor and motor-generator; Selector, including cable, tapes, hoist way selector switches, cams and optical devices; Speed limiting governor, including rope, release carrier, electrical and mechanical over-speed devices, tension weight and sheave; Buffers; Controller components, including starter, supervisory and group operation panels; Power unit components including pump, motor and valves; Hoist way and car wiring / cables; Hoist way and pit equipment; Limit switches; Plunger and packing gland; RIDE EACH ELEVATOR, CHECK OPERATION OF CAR AND HATCH DOORS, SAFETY EDGES, SENSING DEVICES, ACCELERATION AND SLOW DOWN SPEED, FLOOR STOPS AND LEVELING THE SUCCESSFUL BIDDER WILL KEEP GUIDE RAILS PROPERLY LUBRICATED AT ALL TIMES EXCEPT WHERE ROLLER GUIDES ARE USED AND WHEN NECESSARY, RENEW GUIDE SHOE GIBS OR GUIDE ROLLERS IN ORDER TO ASSURE SMOOTH AND QUIET OPERATION. INSPECT AND WIPE CLEAN ALL MOTORS, MACHINES AND GENERATORS. WIPE CLEAN ALL MOTOR AND COMMUTATORS CLEAN AND CHECK BRUSHES AND BRUSH HOLDERS CLEAN AND LUBRICATE DIRECTION AND ACCELERATING SWITCHES LUBRICATE THE GOVERNOR SHAFT BEARING CLEAN THE HOIST WAYS, LANDING AND CAR SILLS CLEAN, LUBRICATE, ADJUST DOOR MONITORING EQUIPMENT WIPE CLEAN ALL MOTORS AND PUMP UNITS