Specifications include, but are not limited to:Specifications 1. Unit: A.Heavy duty, ten (10) wheel dump truck cab and chassis with GVW of not less than 60,000 pounds B.Expected gross combination weight of 80,000 lbs 2. Wheelbase and CT: A.CT shall be a sufficient length to accommodate a 12 ft. (12 yd.) dump body and also plow rigging. This CT measurement shall be approximately 96”; B.AF dimensions must allow for a minimum 12” of frame to extend past the rear tires to facilitate mounting the dump body and brake controls with mounted lighting adapters for a trailer; C.Unit must have both electric and air lines to the rear 3. Front Axles: A.20,000 lb. minimum capacity I-Beam type, such as Detroit DA-F-20.0-5 20,000 lbs 71.0 KPI 3.74 or equivalent; B.Suitable for extreme snowplow and dump truck service; C.Oil lubricated and sealed wheel bearings with visible oil supply; D.Front springs shall be heavy duty designed to support the plow and wing in travel position, under full ballast load with no appreciable sag or deflection on either side; Left spring shall be 9,500 lbs; Right Spring shall be 10,500 lbs; E.Spring mounted hardware and brackets shall be designed for extreme use; F.Front axle shall be set-back type; G. Front shock absorbers 4. Rear Axle: A. Meritor RT-46-160P R-Series tandem axle or equivalent, @ 46,000# GVW; B. Approximately 55 MPH at most economical RPM in high gear; C. Aluminum housings will not be accepted; D. Magnetic oil drain plug;
