Specifications include, but are not limited to: PAINT:__________________________All painted surfaces shall be properly prepared, primed and painted.__________________________Cab shall be painted with a base coat/clear coat.__________________________Cab exterior and body, except top of hood, shall be painted to match PPG # HSB923853 red PPG base/Clear.__________________________Top of hood shall be painted to match Ditzler Stock #DQE 9000 with flattener.__________________________Chassis and under-gear shall be painted black.__________________________Wheels shall be powder coated white
ENGINE:__________________________The engine shall be a standard production; turbo charged; governed; diesel fueled; with a minimum gross torque of 1000 pound-feet, and a minimum SAE gross horsepower of 330 when operated within a governed speed as recommended by the engine manufacturer.__________________________The engine must meet all current emissions regulations and incorporate the use of Diesel Exhaust Fluid. __________________________All lines from DEF storage tank to be made of stainless steel or non-corrosive material in lieu of mild steel. __________________________Provide Optional Pricing for Engine oil pan to be made from stainless steel or non-corrosive material. The engine shall be equipped with all standard commercial accessories, except that in lieu of standard accessories the following items shall be installed:__________________________Engine oil fill tube reachable from ground level.__________________________A heavy duty air cleaner.__________________________A dash mounted Filter Minder lockup type air restriction indicator.__________________________Dash mounted electric hour meter with trip hour meter and oil pressure sending switch or other approved system which records "actual" engine operation time. __________________________The radiator shall contain extended life antifreeze to -30° F protection.__________________________Hand or electric fuel priming pump.__________________________An easily accessible electric heated fuel water separator. Factory installed muffler and vertical tail pipe with a 45-degree side turn out with an approximate height of 10 feet3 inches. Tailpipe and elbow to be removable to allow height adjustment during body installation. All components shall be aluminized steel or other corrosion resistant material.__________________________Thermostatically controlled 1,000-wattminimum block heater with weather resistant male electric socket receptacle on the front bumper outboard of the frame brackets or behind the front fender.__________________________Electronic engine idle shut down capability. KDOT parameters to be given to bidder by KDOT Equipment Section. __________________________Factory installed engine alarm system with warning light and buzzer to signal low oil pressure or excessive coolant temperature.__________________________Electronic throttle control shall be mounted in the cab.Control shall allow for high idle to be disengaged by tapping foot brake when truck is in neutral and parking brake is set. __________________________Engine tachometer accurate within 50 RPM at all speeds shall be mounted in the dash.__________________________An air-clutch cooling fan designed for fail-safe operation.
MECHANIC TRAINING __________________________A3day, "hands on" technician training session shall be provided at each KDOT District Shop. The training session topics will be coordinated through KDOT Equipment Section and may include but are not limited to diesel engine tune-up and maintenance, multiplex systems, and use of purchased software. The training session shall accommodate at least 12 KDOT mechanics at each session. Training shall be provided approximately 12 months after delivery of units.