Specifications include, but are not limited to: izers and agents blended to result in a product that seals cracks in pavements from water intrusion. The sealant must retain adhesion and flexibility during extremes of expansion and contraction of the crack through a temperature range of 0ºF to 140ºF. Heat and apply the material according to manufacturer’s recommendations. b. Bond. When tested at -20oF to 200% extension of 1/2 inch to 1-1/2 inch for 3 cycles, the material exhibits no cracking, separation, or other opening that at any point is greater than ¼ inch deep in the sealer or between the sealer and the mortar block. A minimum of 2 test specimens in a set of 3 representing a given sample must comply with this requirement. c. Flow. 5 mm maximum. d. Resilience. 50 – 80% recovery. e. Cone Penetration. 0oF, 150 grams, 5 seconds: 18 – 80