Specifications include, but are not limited to: General ConstructionA front opening robe with twin front panels that are approximately 3 inches in width and triple-ply in construction. Two fully pressed-in pleats on each side of the front panels extend from the base of the yoke to the hemline. Balanced machine fluting in a ratio of 3 1/2 inches of flat material to each inch of fluting to extend over the shoulders and across the back. A concealed zipper is required and must be attached to a double layer of material for more durability. The zipper length to be graded according to the robe size. The body hem to be 3 inches deep. Fabric Royal Mystique Satin with Silver Mystique satin accents. Yoke Construction The robe to have a full-coverage yoke with an easy-to-close, secure velcro closure at the neckline and a standing collar. A second color to be used to dramatize the standing collar. The robe to be tailored in two pieces and designed to fit the shoulders naturally and also the grain of the material to run parallel across the front and back. The common one piece yoke is not acceptable. No visible stitching to appear on the outside of the yoke. The inner yoke to be tailored from lightweight, shrink-resistant pellon, which is then topstitched to a cloth backing for even greater shape-retention. A large rust-proof hook and eye closure to be permanently riveted to the lining material to eliminate the need for future repairs. Hand-sewn hooks and eyes are not acceptable. Monogram S A 2” on the left side of the yoke as worn in silver MAD 1011 thread, letters to be staggered and connected. Sleeve ConstructionLong, gracefully flowing sleeves with sixteen-inch drop from the wrist to the tapered end. A contrasting colored sleeve lining to extend approximately half-way up the inside of the sleeve. A 3-1/2 inch turnout of the lining material to highlight the outside of the sleeve for more contrast. Sleeve lengths are graded to the height of the individual.