Specifications include, but are not limited to:Shawnee County is soliciting sealed bids for two (2) new/unused 2016 Heavy Duty Tandem axle Dump Trucks with snowplows, snowplow mast, sander and liquid de-icing systems per the following minimum specifications.Engine: EPA 2016-compliant Turbo charged mid range diesel SAE rated @ 325 HP / 1000 lb ft of torque minimum. The engine shall be diesel fueled wet sleeve design with a minimum of 8.9 liters, turbo exhaust brake controlled from a dash mounted switch. The engine shall have a low oil pressure and high engine temperature engine shut down system. The engine must use an S.C.R. system to achieve compliance with E.P.A. 2016 emission standards. The fan will have a Horton two speed air operated clutch. The DEF tank shall be 11 gallons minimum of usable volume, located on LH side of chassis. Exhaust must be RH under cab DPF/SCR w RH SOC vertical tailpipe. Shall have Cummins 18.7 CFM air compressor. Shall have engine mounted Power core air cleaner w/constant torque SS clamps, pop-up air flow restriction indicator. Shall have immersion engine block heater 120V 1000W. Shall have multi-function engine connector for body builder; body builder harness to EOF for customer installed remote throttle control. Shall have 180 amp alternator; fuel cooler required; must have heated filter/water separator w/WIF sensor. Starter shall be 12V electrical system w/centralized power distribution. Batteries shall be 3 group 31 Threaded post (700) 2100 CCA. Battery box shall be cantilever aluminum BOC w/fiberglass cover, mounted on RH side. Shall have jump start terminals under hood. Transmission: Allison 3500 RDS 6-speed with touch pad shift, touch pad must be mounted in/on dash with easy access to driver. heavy-duty external oil cooler and auxiliary oil filter. Frame:Heavy Duty to carry dump body and sander. Frame shall be extended 20” in front for front mount hydraulic pump, and snowplow mast reinforced per manufacturer's standard. Wheelbase should be approximately 204” and provide a minimum of 19’between center of front axle and center of extreme rear axle
