Specifications include, but are not limited to: A. Tanks must be made from medium density polyethylene, MDPE and have a minimum wall thickness of 3/8-inch. B. Tank dimensions must be approximately 111-inches long by 30-inches high sloped down to 24-inches in height by 24-inches wide and have a capacity of approximately 263-gallons. C. Each kit must have two (2) tanks, (1) left and (1) right, and slope to the center of the dump body when installed. Each “pair” must have an approximate total combined capacity of 526-gallons. D. Design must be heavy-duty with baffles and reinforced corners. Tank design must allow tanks to fit properly on the bottom, side and front of Department dump bodies. E. Each tank must have a total of three (3), 3-inch diameter holes, two (2) vent and one (1) outlet. Vent holes must be located on the top, one each end. Outlets must be in the rear facing end of each tank near the bottom.