Specifications include, but are not limited to: Carpentry Work Framing New stud walls within existing office, work areas, etc. Studs: “C” shaped w/ flat or formed webs w/ knurled faces Runners: “U” shaped, sized to match studs Ceiling channels: “C” shaped Furring: Hat shaped sections Install framing to city of Des Moines code Framing materials may include metal and/or dimensional lumber Reinforce rough openings as required for hardware in openings using less than double studs Repair damaged walls Other framing as needed on a project-by-project basis Finish Install doors and hardware Flooring: Carpet squares, VCT, Ceramic & quarry tile Apply molding (case, base and crown) Install new cabinetry – set and secure cabinets in place, so they are rigid, plumb and level Repair existing cabinetry ranging from material damage to hardware failure Use concealed fasteners to align and secure components. If unable to countersink anchorage devices at exposed locations, then conceal with w/ plugs to blend in with surrounding material. Adjust all hardware to close smoothly, appropriately and with even gap. Removal of any existing cabinetry Other finish carpentry as needed on a project-by-project basis Drywall Installation of gypsum board in most economical direction, w/ end and edges occurring over Firm bearing Wallboard sized to minimize joints in place, ends square cut. Edges are to be tapered Corner beads: galvanized steel Edge trim: “U” bead Joint Materials: As recommended by gypsum board manufacturer Screws self-piercing tapping type galvanized or coated to prevent rust Anchorage of substrate Nails, screws and other metal supports to be type and size to suit application and secure materials in place. Installation over metal or wood studs with glues and/or fasteners appropriate for the job. Drywall type and thickness to comply with city of Des Moines code. Tape, fill, and sand exposed joints, edges and corners to produce a smooth surface ready to receive finishes Level 4 finish Repair patches in existing wall where damaged Apply texture to the walls and ceilings as specified by the project Other drywall work as needed on a project by project basis