Specifications include, but are not limited to: A. Examine each piece of equipment and device to see that it is functioning properly and is in good operational condition. B. Clean all components of dust, old lubricants, etc. to allow the equipment to function as designed. C. Lubricate all equipment to permit bearings, gears, and wear points to operate freely and without undue wear. D. Adjust all linkages, motors, drives etc. that have drifted from the initial design settings and positions. E. Calibrate all sensing, monitoring, output, safety, and readout devices for proper ranges, settings, and optimum efficiencies. F. Chillers: Manual valves, float valves, direct expansion valves, thermometers, gauges, magnetic starters, manual motor starters, pump and fan motor drives, belts, electrical wiring, check valves, refrigerant piping and insulation and refrigerant levels will be maintained in original operating condition.