Specifications include, but are not limited to: The Illinois Secretary of State is soliciting bids for the annual maintenance of generators/fire pumps and an hourly rate for appropriate repair as approved by the Secretary of State designee. Cooling System Visually inspect Radiator/Heat Exchanger of leaks, damage, and debris. Check Louvers are operating correctly. Visually inspect Coolant for correct levels and condition (rust, oil: contaminants). Check coolant conditioner concentration and temperature protection. Check filler cap gasket and sealing surfaces. Visually inspect hoses for deterioration. Check tightness of connections. Check Fan Drive Pulley and Fan for loose or worn pulleys and lube fan drive bearing. Check fan operation and clearance. Inspect Fan Belts for wear and deterioration. Check tension and adjust as necessary. Check thermostat setting for proper coolant temperature. Check Water pump operation, inspect for leaks or unusual noises. Fuel System 1. Visually inspect fuel tank system for leaks and fuel level. Test day tank pump for operation. Inspect fuel condition for contaminants. 2. Drain water from fuel tank or water separator. 3. Inspect Fuel line and connections for leaks and tight connections. Check line brackets. 4. Inspect Governor and Controls, check governor oil level. Inspect controls and linkage for proper operation. Add oil as necessary. 5. Inspect Fuel filters – Primary / Secondary for damage, leaks, and proper operation. Clean primary filter. 6. Check Fuel Pressure gauge for correct pressure. Air Induction and Exhaust System 1. Inspect Air Filter. Clean as necessary 2. Inspect Air Inlet System piping and air filter housing for damaged, loose connections, and evidence of leaks. 3. Inspect Turbocharger for oil leakage or exhaust leakage. Check for unusual noises and proper operation. 4. Inspect Exhaust Manifold for damage, loose or missing hardware, evidence of exhaust leakage. 5. Inspect Exhaust System silencer and piping for damage, corrosion, or leakage. Check rain cap. Check supports for vibration damage and loose connections. Lube Oil System 1. Inspect for correct oil level and /or contamination. Visually inspect unit for leaks. 2 .Check Oil Pressure gauge for correct pressure. 3. Inspect Crankcase Breather for proper operation.