Specifications include, but are not limited to: A. General 1. Three (3) Single Axle Dump Truck - Year____________ Make_________________ Current Model Year International Workstar 4 X 2, Approximately 185” W/B, 116” CA Ft Frame Ext or equivalent Model___________________GVWR________ Note: Overall CA to be verified by chassis dealer and builder 2. Truck required to be able to clear viaduct height of 10’ 2” with no exceptions ______________________________________ 3. Please list turning radius of truck being specified ______________________________________ TRUCK CHASSIS B. Engine 1. Minimum 300 HP electronic, sleeved engine with ______________________________________ grid heater, able to produce minimum 800 ft lbs of torque, Specify turbo-charged and after-cooled, Make_________________Model____________ Cummins ISL9 or equivalent 2. Engine block heater, receptacle on driver’s side ______________________________________ 3. Integral winter/summer air cleaner valve with dash mounted control cable. 4. Thermostatic fuel temperature controlled electric heater and fuel filter restriction/change indicator in a single assembly mounted on engine. Fleet Guard fuel/water separator FS1968400P, or equivalent. ______________________________________ 5. External oil cooler, engine mounted ______________________________________ 6. Heavy duty cooling system ______________________________________ 7. Provide fuel efficiency information- EPA Standards ______________________________________ 8. Optional: Cowl Cover for air intake. Additional Cost: ______________________________________ C. Transmission 1. Allison RDSP3000 6-speed automatic transmission ______________________________________ 2. Shift and indicator mounting located on the dash. Column and floor mountings will not be acceptable. ______________________________________ 3. Push button control selector with lighted position indicator. Indicator shall clearly show all 6 ranges plus neutral and reverse. ______________________________________ 4. Internal element-style transmission oil filter ______________________________________ 5. Oil level sensor with Allison transmission ______________________________________ 6. Power take-off (PTO) opening shall have two accessible SAE eight-bolt, engine-drive openings, one on each side of the transmission ______________________________________ 7. Dipstick tube installed on right side for easier access for PTO repairs. ______________________________________ 8. External transmission cooler ______________________________________ D. Frame 1. Min. 110,000 PSI frame ______________________________________ 2. One-piece type frame, full width ______________________________________ 3. Full-depth frame reinforcement ______________________________________ 4. Front frame extension with reinforcement ______________________________________ 5. Two front-mounted tow hooks mounted to frame ______________________________________ E. Axles 1. 16,000 lb capacity, I-beam front axle & 16,000 lb heavy duty front spring with front auxiliary rubber overload springs ______________________________________ 2. 23,000 lb capacity rear axle & 23,000 lb rear springs with 4,500 lb auxiliary overload springs ______________________________________ 3. Axle ratio shall be as required for a top road speed of 65 MPH. ______________________________________ 4. SPL (long life) drive lines ______________________________________ 5. Single power steering ______________________________________ 6. Optional: Dual power steering. Note: If unavailable as an option, please indicate specifically, otherwise include the Additional Cost:
