• Sand blast or grind surfaces to remove existing coatings on pool floor, walls, and stairs in both the main pool and dive pool. Main / Lap pool is 5,620sq ft. Dive Pool is 2,039sq ft. • Mask and protect all stainless steel and drains. • Clean up and remove all blasting media and debris. • Grind, cut, route and patch as needed existing cracks within pool floors and walls. • Proposal includes allowance for minor patching/skim coating of walls after blasting to repair any pitted areas. Major repairs to walls are not included. • Prep and patch as needed any broken and spalled concrete on pool floor. • Remove existing sealant from all joints within main pool and dive pool. This includes the horizontal joint on pool wall under the perimeter gutter. Joint between gutter and pool deck is not included. • Scrape and prep joints for new sealant including backer rod replacement. • Prime joints with Vulcum 171 primer and apply 45SSL Sealant or an approved equitant. • Apply two coats of approved epoxy coating to the entire main pool and dive pool including all floors, walls, stairs, stair edges, lane lines and targets. • Aggregate to be added for slip resistant finish as required by Owner. • New paint to be minimum of 5 mils and maximum of 8 mils. • All work shall be complete by April 30th 2026
