Specifications include, but are not limited to: Contractor shall carefully examine the site of the proposed work. The contractor shall remove existing coatings, repair cracks and damaged areas with filler, grind displaced areas and cracks, repair concrete (where applicable) and grind repairs flush with courts, resurface courts and paint new lines to specifications. Contractor shall provide daily cleanup and disposal, storage containers, dumpsters, hauling, and pay fees for disposal of materials removed from site, dust control, and sweeping. 1. Contractor shall make a thorough examination of the site to determine all existing conditions affecting the work 2. Contractor, at its sole expense, shall perform continuous site cleanup of the construction site daily 3. Remove nets, center straps tie downs, posts, sleeves, and footings 4. All surfaces need to be power washed 5. Perform a water test and mark areas of depressions and low spots (test to be performed after surface has been cleaned) 6. Repair all chipped, spalling, and depressions with Court Patch Binder 7. Install expansion joints 8. Replace nets, center straps tie downs, post, sleeves, and footings Project will include maintenance, repair, and resurfacing of the tennis courts at Lewis & Clark Middle School: 1. Remove existing coatings and any loose material 2. Repair concrete and grind repairs flush with courts, as needed 3. Remove and replace expansion joint caulking (if applicable) 4. Resurface courts and paint new lines to specifications 5. Remove and replace tennis courts nets, center straps, and posts 6. Furnish and install all other required materials, equipment, and labor not identified but necessary to complete the project 7. Apply one acrylic resurfacer coat on all court surfaces 2. Apply 2” wide white tennis court striping — in accordance with USTA requirements 9. All cracks to be filled with acrylic binder mix per manufacturer specifications 10. If necessary, grind all surfaces level to the existing surface 11. Apply acrylic resurfacing sand — all repairs need to be hidden and blended 12. Apply textured acrylic resurfacer per manufacturers instruction 13. Apply coat of colored textured 100% acrylic latex 14. Apply approved top coat per manufacturer instructions 15. Apply acrylic primer 16. Fill and match color — surface needs to be flush