Specifications include, but are not limited to: Conventional day cab, air ride driver’s seat, non-air ride passenger seat, high visibility seat belts, mirrors (2) thermostatically controlled heated heads, convex both sides flat glass, convex look down mirror on the right side, hood mounted convex mirrors right and left sides. Dual frame mounted cab rear air suspension, with special cross member assembly. Exterior sunshade painted roof color with integral clearance lights. Grab handle exterior. Tilting front end, with fender extensions and bug screen mounted behind grill, four (4) LED amber/clear warning lights within grill. All LED amber/clear warning lights on front, rear and side of cab. Additional rear direction arrow LED stick in back of truck. Grill: chrome vertical accent bars with black mesh Paint: winter white (9219) Factory installed heater/ac Keys: 4 includes ignition and cab door locks Multi-piece hood construction that allows the entire fender to be replaced, independent of hood. Hood shall be constructed of Metton material to reduce weight, and better resist star cracking (no fiberglass) All aluminum cab construction with bonded and riveted joints required for corrosion resistance, cab joint integrity, and low cost of repair. No dissimilar metals to minimize galvanic corrosion. Continuous piano style stainless cab door hinges required for strength, door alignment durability and corrosion resistance. Flat panel aluminum bulkhead style door design required for increased cab strength, and low cost of ownership Power windows and door locks for both driver and passenger side shall be provided for driver safety and convenience. Cab shall be equipped with overhead storage console pockets on both driver and passenger sides with retainer nets/or doors to secure them. 1piece windshield with a surface area of not less than 1646 sq. In. This is required for improved jobsite visibility. Cab rear window shall measure not less than 52" wide for a panoramic view to the rear of the vehicle. Windshield wiper swept surface area shall be not less than 900 sq. In. For optimum visibility during inclement weather. Cab width shall be a minimum of 68.5" at dash between a-pillars to provide room for in cab mounted equipment Cab height form floor to roof shall be a minimum of 52.5" at edge of seat to ensure adequate room for a variety of drivers Measurement from center of fuel pedal to back of cab wall shall be not less than 44 inches, to accommodate leg room. 4.3 STEERING Tilt/telescoping steering column shall be provided for driver comfort and convenience to accommodate a variety of operators Tilting and telescoping,steering wheel 4-spoke 18" diameter BLACK Steering system shall include dual power gears, to provide maximum torque to steering arms, A SINGLE GEAR AND SLAVE CYLINDER IS NOT ACCEPTABLE. Turn angle greater than 38 degrees in both directions with 425 tires required for job site maneuverability and service access.