The truck described shall meet the minimum requirements that follow: • Insulated 40ft. articulating, telescopic aerial platform lift, 45 ft. working height • Standard platform capacity of 350 lbs. • Isolating system. • 180-degree platform rotator. • Full pressure turret mounted lower controls including override. • Engine start/stop system with controls at platform and lower controls. • Chassis insulating system including fiberglass compensation link providing 12 inches insulation gap. • Fiberglass inner boom. • Integral hydraulic oil reservoir with dual sight gauges and 15 gal. capacity. • Hydraulic leveling with upper control to tilt for clean-out and rescue. Leveling control at lower controls. • End mounted closed 24 in. x 30 in. x 42 in. fiberglass platform with one-step, liner and cover. • Mounting hardware for chassis/cab installation • Non-lube bearings used at all pivot points. • Boom cradle and ratchet type tie down strap. • Automatic throttle control. • 12-volt DC backup pump providing power to all boom functions. • Painted standard white urethane. • Full body harness and lanyard. • Two operator’s manuals and two service manuals. • Bluetooth and back-up camera, etc… Steel Body 132” long x 42” high x 94” wide service body or equivalent including: • 30 inch platform extension • Fouts LED lighting package in tail shelf • Rear access only 42” High Street side compartments: • 1st Vertical: Two (2) adjustable shelves with dividers • 2nd Vertical: Two (2) adjustable shelves with dividers • Horizontal: One (1) removable shelf with dividers • Rear Vertical: Two (2) adjustable shelves with dividers • Access door in the tail shelf for storage 42” High Curbside Compartments: • 1st Vertical: Two (2) adjustable shelves with dividers • 2nd Vertical: Grip strut access steps to bed area with removable plastic tail board. • Horizontal: One (1) adjustable shelf with dividers Installation to include the following: • Mounting hardware, PTO and pump. • Rear torsion bar and ballast • Steel service body and accessories • Combination pintle hitch with 2 inch ball, D rings and 7 prong trailer connector. • Tow (20 amber strobe lights in tail shelf and Two (2) strobe lights in front grill. • Mud flaps, back up alarm, and park brake interlock system • Test and certify per ANSI A92.2 • 2000-watt pure sin inverter • Tool bin • Headache RACK (similar set-up to the GDOT units) • Pipe vise on tail shelf at street side • Extra storage and no side entrance on the body
