1. All work is to be performed in accordance with the GDOT ROW master abatement and demolition specifications issued on June 1, 2018 by ROW’s State Property Manager, Demolition & Removal. Demolition workers must show evidence of having attended a GDOT approved awareness training program. This structure (S1) has been damaged by large tree fall onto structure after original inspection. Some original inspection photo’s are still a part of the “ACM & Pre-Demo Report” so that material items and areas can be better understood. The work should be performed in a manner to not endanger workers or generate liability to all involved. For that reason the Demolition Contractor will be allowed to strip away exterior finishes and treat that material as General Construction Debris. Once that effort is maximized the balance of materials MUST be treated as ACM and disposed of accordingly in an approved landfill. Site Inspector strongly advises site visit to assess conditions and material quantity prior to bid submittal. 2. Asbestos abatement includes: S1 - Int. Misc. VSF (196±SF), brown/orange tile pattern, Kitchen (21.75'x9'), bottom layer of 2 layers. Int. Misc. DW/JTC walls/ceilings - 6334±SF. MI1 - NA; MI2 - N/A; MI3 - N/A. S2 - None. 3. Demolition includes: S1 - Residential (2630±SF) wood-frame, brick veneer house with shingle roof and crawl space converted to (8/2) commercial use. Fist sized landscaping (720±SF) rock from S1 front landscaping. Covered front (278±SF) concrete/CMU porch, front porch (6’3”x10’3”) concrete landing, covered rear concrete stoop (98±SF) & WF rear (141±SF) deck both of which have a 39”±ht., Rear WF deck 4”x4” posts are set in concrete footers. Concrete (348 ±SF) sidewalk @ S1 front & rear. Concrete (13’6”x8’4”x5”±ht) walkway (cut clean) from right side of S1. Asphalt & concrete (4121±SF) mix drive/parking area as marked - cut clean lines as marked. “Do Not Disturb” area of drive is to allow access to rear of parcel and buildings for Owner. There is a (10.5’x13’) concrete pad under WF sub-floor in front right room. Structure has an original (circa 1960) asphalt shingle roof line in existing attic space. Remove electric meter panel and two electrical panels that control underground feed from S1 to two (2) other structures (Showroom building to right of S1 and Workshop to rear of S1) that are to remain. Track, trace, and remove underground conduit/electrical feed lines to Demolition Easement or ROW as appropriate. Clear/remove propane tank feed line. MI1: Remove/clear six (6) stainless steel banner receivers found various locations along parcel front. MI2: Remove/clear WF sign framework and associated footers. WF sign frame consists of three (3) 8”x8”x7’±ht posts set in concrete and four (4) 2’x4’ boards that are 10’9”± in length. MI3: Remove/clear two (2) steel (1.75”x1.75”) poles / receivers cut at ground level from concrete parking / drive. These cut off poles may have concrete footers associated with their original install. S2 - CMU/concrete/brick (6’x7’x4’9”±ht) well house with wood-frame shingle roof. Electric conduit/lines and water service lines are to be removed. Water service lines are to be capped in accordance with GDOT R/W requirements. Septic tank is to be pumped dry and removed along with the drain lines. Well is to be capped, marked, and flagged/barricaded per GDOT ROW master demolition specifications.
