Specifications include, but are not limited to: A. Form No. 82994, Motor Vehicle Title Reassignment Supplement 1. Parts: Two (2) part, carbon interleaved. 2. Size: Overall 8 1/2” W X 11-1/2” H; snapped out to 8-1/2” W x 11” H. 3. Perforations: All parts shall be horizontally perforated below top stub. All sheets will be glued at the top of form. This horizontal perforation must be strong enough for form to hold together while going through a printer. 4. Security Printing: Fine line lithographic prismatic tint including a “copy void” pantograph printed in fluorescent erasure sensitive inks on face of original copy. Colors will be selected by the Department and the Contractor. The paper will be treated to detect chemical alterations. Any attempt at alteration will be apparent by inspection without special devices such as flashlights. 5. Paper Stock: Enhanced sensitivity white paper which reacts to alteration chemicals. The paper must be carbonless paper, black impression, in order to produce clear legible prints. 6. Ink Requirements: Border-999 Black; Front-999 Black, Back-423 Grey. 7. Printing: In accordance with the sample attached (see Exhibit 5 to the ITB). Sample shows printing and fine line geometric border that shall be printed on all copies (2/set) front and back. Additional minor adjustments to the printing settings may be approved in writing by the Department’s Contract Manager after the bid award. The Contractor will be required to set-up and furnish its own artwork at no additional expense to the Department. B. Form No. 82995 Motor Vehicle Power of Attorney/Odometer Disclosure 1. Parts: Three (3) part, carbonless snap out. 2. Size: Overall 8-1/2” W x 11-1/2” H; snapped out to 8-1/2” W x 11”H. 3. Perforations: All parts to be horizontally perforated below top stub. All sheets shall be glued at the top of form. This horizontal perforation must be strong enough for form to hold together while going through a printer. 4. Paper Stock: Enhanced sensitivity white paper which reacts to alteration chemicals. The paper must be carbonless paper, black impression, in order to produce clear legible prints. 5. Ink Requirements: Border-999 Black; Front-999 Black, Back-423 Grey. 6. Printing: In accordance with the sample attached (see Exhibit 5 to the ITB). Sample shows printing and fine line geometric border that shall be printed on all copies (3/set) front and back. Additional minor adjustments to the printing settings may be approved in writing by the Department’s Contract Manager after the bid award. The Contractor will be required to set-up and furnish its own artwork at no additional expense to this Department.