Specifications include, but are not limited to: Inspections shall include at minimum, the following: Verify performance of all wells/pumps to include static pressure, dynamic flow, and pressure not only by design, but also according to manufacturer’s pump curve. Test pump control panel and verify that all connections and surge protection components are functioning properly. Verify all motor amperages at full load are within specifications. Check and document running amps on well pumps and compare to manufacturer’s specifications. Confirm pump flow and pressure performance. Test flow meter and pressure transducer for proper operation. Open and inspect all motor and variable frequency drive connections to prevent catastrophic failure from heated connections. Inspect wiring and connections for signs of overheating and deterioration. Inspect electrical conduit verifying all connections are secure. Service/grease pump motor bearings and check/maintain oil level (if applicable). Inspect and test pressure tanks for items such as cracks, structural damage, leaks, corrosion, and verify proper air pressure according to pump start pressures. Check condition of pump seal/packing. Inspect piping condition.
