20 Ton Truck Mounted Cone Penetrometer Testing (CPT) System Scope of Work: Provide 20-Ton Truck-Mounted CPT Rig The CPT rig must include and/or meet the following needs: Peterbilt vocational truck chassis with: Day cab Single channel frame 2,000,000 Minimum RBM frame rating 300 HP minimum engine output 18,000-lb minimum front axle 40,000-lb minimum rear axle 220-240” wheelbase depending on front axle position (set back/ set forward) Vertical exhaust PTO provisions Body builder harness to allow aux idle controls and e-stop installation inside cabin Side and top of frame rails clear 40” behind cab 150-amp minimum alternator output 120” minimum rear frame overhang Rear cabin with: Insulated walls and ceiling Aluminum interior and exterior Five 24” X 18” sliding windows w/ screens, four in the side walls and one in the door Lockable main entrance door, 32” X 80” Roof opening with locking hatch above push frame Easy stow away ladder 2,000-watt pure sine wave AC power inverter Two interior lights with sealed fixtures Interior 120V AC Outlets, 120V exterior outlets w/ covers on either side of the door HVAC system with thermostat control Utility Sink Painted steel floor (black) Rear deck with railings Customized Cabin Wrap Work bench with: Stainless steel top 6-drawer locking cabinet Custom heavy-duty vise for sure grip on rods or cones
