Specifications include, but are not limited to: 1.Abrasive (Sand) Blast all existing pool walls, floor and steps to remove paint coatings and parge coats previously used to patch walls. Following completion of Abrasive (Sand) Blast, all surfaces are to be repaired, cleaned, prepared and painted with new High-Performance Coatings. Pool Paint color to be White. Accent paint to be Black. Refer to Specification Section 099600 for preparation and painting of pool. 2.Remove loose and damaged concrete by hand-chipping. Saw cut or chisel edges as required for proper installation of new Portland Cement-Based Patch. Where chipping around anchors, take precautions to prevent damage. Refer to Details and Specification Section 049500. 3.Properly prepare cracks, where indicated, including removal of elastomeric sealant and preparation of the cracks Repair crack with Liquid Polyurethane Injection as indicated in Specification Section 031400. 4.Remove existing sealant at base of wall for full pool perimeter and at vertical construction joints and replace with new. Refer to Specification Section 079200. 5.Provide recessed cup anchors (Typical of 4), including chipping, bonding to rebar and grouting solid.