Specifications include, but are not limited to: (1). Unless expressly stated otherwise, the Contractor shall perform janitorial services in all general building areas. (2). The Contractor shall use commercial grade vacuum equipment that has been tested and approved under the Carpet and Rug Institute’s (CRI) Seal of Approval/Green Label (SOA/GL), such as the CleanMax CMNR-QD 10 Amp Nitro or equivalent. (3). The Contractor shall use microfiber mops and cloths to wipe surface areas clean. To reduce cross contamination, microfiber mops and microfiber cloths shall be changed out frequently during evening services and shall not be shared between rooms. Microfiber mops and cloths shall be cleaned and sanitized daily. (4). The Contractor shall follow low environmental impact cleaning practices (Green Housekeeping; see Exhibit A, Scope of Work, Section O). (5). The Contractor shall require all employees, including supervisors, to wear distinctive uniform clothing (see Exhibit A, Scope of Work, Section K). (6). The Contractor shall provide and maintain Material Safety Data Sheets (MSDS) for each chemical used and stored in the building (see Exhibit A, Scope of Work, Section N). (7). Prior to commencement of work, the Contractor shall provide to the DMV Project Manager and DMV Contract Coordinator a list of all employees assigned to the office to perform services under this Agreement. The Contractor shall provide twenty-four (24) hours advance notice to the DMV Project Manager and DMV Contract Coordinator of any changes to the list. (8). The Contractor and its employees must sign in and sign out upon arrival and departure from the office (must provide legible full name, date, time, and employer name). (1). Restrooms: a. The Contractor shall designate cleaning tools specifically for the restrooms, including microfiber mops, mop buckets, and microfiber towels. To reduce cross contamination, these tools shall be changed out frequently during evening services, cleaned and sanitized daily, and shall not be used in any other areas or rooms of the building. b. Sweep floor to remove all dirt and debris. c. Mop floor with a QUAT neutral disinfectant cleaner/deodorizer (EPA registered, hospital grade germicide for disinfecting and cleaning which complies with OSHA's blood borne pathogen standard for disinfecting surfaces soiled with blood or other potentially infectious bodily fluids). 1. The Contractor shall post wet floor signs when mopping or scrubbing floors. 2. Mix a bacteria killing enzyme deodorizer in the rinse water (similar to Ramsey’s Kil-Oder) and pour mop bucket water down the floor and/or sink drains.