Specifications include, but are not limited to: The Contractor shall perform carpet cleaning and floor maintenance services in all areas of the building. ; Grouted Tile Floors – All Restrooms (Approximately 805 square feet) a. Sweep floors to remove all dirt, loose debris, and grit. Use a doodlebug (hand tool, pad, or extension pole) to clean the edges, corners, and tight areas. b. Power scrub flooring with a high productivity floor stripper (Waxie Pure Annihilator or similar) and a low-speed buffer and stripping pad to liquefy existing floor coating until wax is removed. c. Using a wet/dry vacuum or mop, remove liquefied floor coatings and floor stripper. d. Rinse floor with clean cotton loop mop and clean/clear water. e. Apply three (3) coats of grout and tile sealer (Waxie Grout & Tile Seal or similar) with a looped nylon mop, making sure that each application has thoroughly dried before the next coat is applied. f. Wipe baseboards and any stationary fixtures free of stripping and sealant chemicals. g. If grouted tile extends up the wall, the Contractor shall also apply the cleaning specs to this area(s). Hard and/or Resilient Floors- All Rooms, Except Restrooms and Storage Spaces (Approximately 4,491 square feet) a. Sweep floors to remove all dirt, loose debris, and grit. Use a doodlebug (hand tool, pad, or extension pole) to clean the edges, corners, and tight areas.