MODIFICATIONS: 192 _____Provide modification of streetside ladder to not interfere with underbody boxes when 193 ladder is deployed and body is moving. 194 _____Add an additional ladder on curbside that matches streetside ladder. 195 _____Raise or replace current light bar bracket 6” to allow for forward visibility. 196 197 SAFETY ITEMS: 198 _____A weatherproof 97 Dba. right turn alarm shall be furnished and installed, Ecco model# 210 199 or City approved equal located next to rear wheels on curb side and to activate when right 200 turn signal is engaged. 201 _____Right turn alarm shall be wired to not sound when hazard lights are engaged. EXTERIOR LIGHTING: 203 _____Additional turning indicators to be mounted in the middle of body, one (1) on each side of 204 the body. The lights to be Truck-Lite, LED Super 60, pop out type model number# 60115Y 205 or City approved equal. Truck-Lite sidelights indicators to also activate with the marker 206 lights. It is be wired to the front turn lights. It is acceptable to allow these sidelights to be 207 mounted integrally into the side of body without the use of the brackets. 208 _____Provide and install two (2) Whelen model# P46WLCX Par 46 or City approved equal LED 209 vapor proof floodlights as ground lighting, one (1) each side located beneath the 210 underbody boxes, wired to dash mounted switch labeled: “GROUNDLIGHTS”. 211 _____The brake and turn signal lights to be replaced with Truck-Lite Super44 S/T/T 42 DIODE 212 LED 4” model number #4402R, round rubber grommet-mounted. 213 _____The back-up light to be replaced with a Truck-Lite LED Model 44 sealed, model number 214 #44042C, 4” round rubber grommet-mounted. 215 _____Furnish and Eight (8) Whelen Ion T-series #TLIA amber warning strobes or City approved 216 equal. Install as follows: 217 Two (2) surface-mounted on the front section of truck grille on curb side and street 218 side 219 Two (2) surface-mounted on the above each front wheel well curb side and street 220 side 221 Two (2) mounted on above each rear wheel well on curb side and street side 222 Two (2) mounted to the rear of body on left and right side 223 _____All strobe lights to be controlled through the dash switch panel and properly labeled 224 “STROBES”. 225 _____Provide and install one (1) Whelen model TA125NF2 46" long traffic advisor mounted on 226 top of headboard, below lightbar with in-cab controls and to be wired to truck's battery with 227 in-line fuse. 228 _____Controller to be mounted in a location that is within easy reach of driver. 229 230 COMPARTMENT LIGHTING: 231 _____Furnish and install Buyers LED strip lighting or City approved equal, inside of each utility 232 body compartment. 233 _____Compartment strip lighting to run full length across the top and down each side of all the 234 service body compartments. 235 _____Compartment lighting to be controlled through door pressure switches on each door, 236 switches to be on the ground side of the circuit. 237 _____Power feed to the compartment lights shall be wired hot at all times through factory dash 238 switch. Switch position to be labeled “COMPARTMENT LIGHTS”.
