Specifications include, but are not limited to: A. General Description (1). The eight (8) #9 envelopes measure eight and seven-eighth inches (8-7/8") in width by three and seven-eighth inches (3-7/8") in height. B. Performance Requirements (1). The Contractor shall not over-run total order print quantity. (2). Pallets or deliveries shall be rejected when the Contractor fails to comply with performance criteria. Compliance with dimensions and placement shall be within specified control limits. (3). The DMV utilizes mass mail equipment. Therefore, envelopes shall meet the following performance requirements: a. Envelopes shall not be scored or damaged, e.g., paper threads or hanging shards left by a bad knife cut. b. Seal flaps shall evidence secure, full flap length, non-curl closure, and not stick to contents. c. Seams, windows, patches, and adhesives shall not cause insertion failure. Adhesive shall not result in envelopes that stick to each other before insertion or after sealing. d. Print shall never encroach on postal processing space. Envelopes and print shall comply with United States Postal Service (USPS) specifications found in the Domestic Mail Manual (DMM) Section 102, Elements on the Face of a Mail Piece. e. In eight (8) hours of mail-insertion operations, the envelopes shall not cause more than twenty (20) minutes of equipment downtime from jamming or crashing. C. Construction (1). Envelope Size a. 8-7/8" x 3-7/8". (2). Paper a. Sub 24# white wove. b. Caliper .00470" - .00530" acceptable range, .00488" optimum caliper. c. One hundred seventy (170) plus or minus fifteen (±15) Sheffield Units (SU) of smoothness on the felt side (outside). d. Brightness 90% - 92%. e. Opacity 90%.