The following specifications are provided as minimum requirements only. The City of Moorpark will consider any product/service that meets or exceeds the minimum requirements. Proposers shall provide all pertinent information regarding the proposed product/service for thorough evaluation by the City. Project shall include all labor, equipment and materials necessary to resurface and restripe one (1) multi-use court at Arroyo Vista Community Park for dual use inline hockey and basketball. Contractor shall obtain and pay for any and all permits, fees, or licenses required to perform the work. Multi-use court surface and striping dimensions/measurements including total working area(s) to be verified in the field (site visit) by contractor. All materials, preparation, and subsequent application and construction shall be in compliance with the specifications of the manufacturer of the particular materials used and with the specifications of the American Sports Builders Association (ASBA). Court dimensions shall be in compliance with the National Collegiate Roller Hockey Association (NCRHA), the National Collegiate Athletic Association (NCAA), the National Federation of State High School Associations (NFHS), or California Interscholastic Federation (CIF) standards. Preparation of Courts The existing nets and net posts shall be removed and the surface shall be cleaned and all loose material removed using a “hydroblaster” or high pressure water sprayer (3,500 psi minimum). The city of Moorpark shall provide water access to the court area. All cracks, other than hairline cracks less than 1/16”, shall be cleaned and filled with appropriate acrylic crack filler. All expansion joints between the courts and at the net should be removed and replaced (filled and sealed) with flexible polyurethane sealant or equivalent. All depressions greater than 1/16” should be leveled by filling with an appropriate acrylic based patching mix. All patches shall be ground smooth and if necessary, covered with one or more coats of acrylic resurfacer to obtain a uniform finish. Any spalled areas shall be broken out and filled in the same manner. Surfacing of courts All material is to be new material and mixed on site. All surfacing, coatings, and striping material(s) shall be manufactured by Deco Surfacing Systems and/or California Products Corporation (or equal), including but not limited to: • Plexipave System • Plexipave Court Patch Binder • California Acrylic Resurfacer 920-29 4200 • “Ice Blue” Street Ice S/13 – Acrylic Color for Inline & Street Hockey • Other surfacing systems may be acceptable however must be approved by the City of Moorpark representative, after reviewing provided documentation provided by the contractor and manufacturer The entire surface shall be coated with one coat of acrylic resurfacer according to the manufacturer instructions. The filler and finish courses shall be applied by squeegees. Mechanical spray equipment and spreaders will not be accepted.
