SPECIFICATIONS A. All work shall be performed in accordance with the National Electrical Code and all federal, state, and local building codes. B. SITE WORK: The following are examples of the types of work the Contractor will be required to complete during the course of this Agreement. It is not intended to be “all inclusive.” C. Units to be Maintained and/or Repaired: 1. A/C Unit # 1 Carrier Model #RGS090HDCA0AATA Serial #P154687766 Two stage cooling 7.5 Ton (Filters: 4 @ 16x20x2)) 2. A/C Unit # 2 Carrier Model #RG5060HLCA0AAAA Serial #C151662086 Single Stage unit 5 Ton (Filters: 2 @ 16x25x2) 3. A/C Unit # 3 Carrier Model #RGS090HDCA0AAT Serial #P154186509 Two stage Cooling 7.5 Ton (Filters: 4 @ 16x20x2) 4. A/C Unit # 4 Carrier Model #RGH090HDCU0AATA Serial #P171693165 Two stage cooling 7.5 Ton (Filters: 4 @ 20x20x2) 5. A/C Unit # 5 Carrier Model #RGS090HDCA0AATA Serial #P154186511 Two stage cooling 7.5 Ton (Filters: 4 @ 16x20x2) 6. A/C Unit # 6 Carrier Model #RHH036H0CA0AAAA Serial #C161867187 3 Ton (Filters: 2 @ 16x25x2) 7. A/C Unit # 7 Carrier Model #RGS090HDCA0AATA Serial #P162497200 Two stage cooling unit 7.5 Ton (Filters: 4 @ 16x20x2) 8. A/C Unit # 8 Carrier Model #RGX060HLCA0AAAA Serial #C164983389 5 Ton (Filters: 4 @ 16x16x2) 9. Exhaust Fan 1 – Bathrooms Model #Not visible Serial #Not visible 10. Exhaust Fan 2 – Break Room Model #4HZ446 Serial #15292232 Where specific instructions are not noted for work to be completed, the EDD Representative will supply instructions on a task by task basis. D. UTILITY INTERRUPTIONS: Interruptions to any services for the purpose of HVAC work shall be made only after consultation and agreement with the EDD Representative and shall be at such time and such duration as may be directed. The Contractor shall make necessary provisions as required to maintain existing services to occupied areas with the building. E. THE CONTRACTOR’S RESPONSIBILITIES: 1. It will be the Contractor’s responsibilities to field verify all existing conditions and measurements prior to submitting any proposal. 2. The Contractor shall furnish all labor and equipment necessary to perform all of the services presented in the specifications in a professional, orderly, timely, and efficient manner. The Contractor’s employees, equipment, building materials, etc., shall be restricted to the immediate area of work being performed. 3. The Contractor shall be responsible for removal of all debris, parts, and rubbish generated by performing the services of this Agreement. Any cost involved for removal shall be paid for by the Contractor. 4. The Contractor shall make available, at the job site, a contact person able to communicate effectively with EDD staff who may address concerns or specifications of the Contract.
