1 Securely strap the shared Water Heater unit. Exterior Water Heater Enclosure 1 set Provide and install approved metal straps to the existing water heater (must be minimum 22 gauge thickness x ¾ inch wide). Water heater must be strapped in at least two locations, one being at the upper 1/3 mark of the unit and the other one at the lower 1/3 mark. The lower strap must be a minimum of 4 inches above the water heater control unit. Installation shall comply with current Universal Plumbing Code standards.; 1 Provide and install a new ceiling light combined with an exhaust fan & space heater. (See attached product Tech Spec sheets for the Broan-NuTone brand Bathroom light / fan / heater. Model # BHFLED 110) Bathroom Ceiling 1 $ $ Provide and install a new combined light & exhaust fan with electric radiant-heating blower device in compliance with all applicable building codes. Properly install the appropriate electrical gang box for three light switches or a three-paddle rocker switch to operate the ceiling light, exhaust fan and heater independently of each other. Connect to a new or available 20-amp circuit. Install ducting to properly vent to outside the unit. Note: Contractor will install a new 20-amp circuit breaker into existing electrical panel, if necessary. Repair & paint the affected adjacent ceiling surfaces to match existing color.
