Vehicle Base Specifications • Extended cabin 4X4 56” CA • 6.2 liter – V-8 engine • Four (4) sets of keys – A set of keys consists of ignition and door key, or combination ignition/door key. If the keys do NOT have a remote (door lock/unlock) feature built in, three (3) remotes per vehicle must be included in addition to the four (4) sets of keys. • Paint: white • Spare tire, wheel, and jack • Pickup box delete • Full vinyl flooring • Cloth seating: black or dark grey • Limited slip differentials • Skid plates • Backup alarm • Rear camera prep kit • Platform running boards • Tow package including trailer brake controller • 275/70Rx18E BSW all-terrain tires Additional Specifications • Alley lights & strobe light located as shown in photos, individually switched • Pacific Animal Control Body, box configuration to be identical to photos • Class V hitch with 7-pin FLAT connector. 5/16X1 Ball, Hitch Lock (see photo) • 12-volt power for winch w/circuit breaker 100A (see photo) • Backup sensors with audible alarm • Compartment floors: 2” slope from center to outside • Doors: louvered for ventilation, recessed stainless steel 3-point twist type locks, double paneled 18- gauge stainless steel • Roof: ribbed • Ventilation: full length vent tunnel or equivalent, roof vents as needed (see photos) • Interior lighting: two dome lights with guard and all wiring protected (see photos) • Dead animal compartment: completely sealed from all other compartments, dead animal tray made from .100 5052 aluminum, 60” long, 23” wide, and 11” tall, with handles and 3/4” lip around top edge “L” shaped channel used to prevent tray from sliding into side of compartment in both upper and lower compartments (see photos) • Paint: primered – heavy duty etching, primer topcoat – acrylic urethane • Interior framework: 1” X 2” rectangular stainless steel • Exterior skin: 16-gauge stainless steel side skirts, 16-gauge stainless steel roof, bulkhead, and back panel • Compartment floors: 16-gauge stainless steel • Inner doors: panel: #13 expanded metal, INNER DOORS TO BE SPRING LOADED BREAK-AWAY TYPE • Frame: ¼” X 1 ½” H.R. stainless steel flat bar • Interior partitions: #13 expanded metal (stainless) • Cross members: 10-gauge stainless steel • Underside of body: completely undercoated • Curbside slide in ramp: anti-slip texture on entire top of ramp surface; when compartment door is closed it must prevent ramp from coming out (see photos) • Air conditioning unit: centrally located on box, switches inside cab (see photos) • Corner strobe lights: amber alternating flashing corner strobe lights, hidden inside front marker/cornering light assemblies and rear tail/back-up light assemblies, switched inside cab, Sound Off ETKG09AAAA or equivalent (see photos) • Remote spotlight: go-light or equivalent remote-control spotlight, mounted in center of cab roof, roof to be reinforced to prevent flexing from light installation. A wireless remote control. Spotlight hardwired into trucks electrical system with stand-alone on/off switch. (see photos)
