Specifications include, but are not limited to: 1.General: This specification is intended to cover a diesel powered portable asphalt milling machine which attaches to the front bucket of a loader. The physical dimensions of machine shall allow the machine to fit standard loader buckets without the sides or top of the bucket hitting the machine. 2.Engine: Water cooled, four cycle diesel developing a minimum of 170 HP at rated RPM. Shall be equipped with 12-volt electric system including starter, battery, alternator and charge indicator. Shall have governor, lube oil and fuel filters, approved type air cleaner, muffler, fuel tank and all necessary gauges and equipment for efficient operation. Fuel tank shall have a capacity for no less than ten (10) hours of operation. Cooling system shall have anti-freeze protection to -20o F, or lower.3.Instrument: Shall be remote type which can be kept in the cab of the loader to allow the operator to monitor engine functions without leaving the cab. Shall include tachometer, engine emergency stop switch, electric hour meter, fuel level, engine oil pressure gauge and engine temperature gauge.4.Control Panel: This panel shall contain the following controls and reading, a key switch for engine start, run and shutoff, emergency stop, engine speed, cutting depth, bucket clamp, belt tension indicator and skid foot down pressure.5.Remote Control: A hand held wireless remote control shall be provided that allows the operator to shut the engine down, adjust engine speed and control cutting depth.