Specifications include, but are not limited to: 1. Steel Strain Traffic Pole Assembly Each traffic pole assembly shall consist of a steel strain pole (28 ft. or 37 ft. option) with base plate, and all accessories represented by such items as anchor bolts/nuts/washers/beveled washers, anchor bolt template, hand holes & covers, set screws, wiring holes, top cap, (2) span wire clamps, etc. and meeting or exceeding these specifications and the attached drawings no.1. These poles will be qalvanized, not painted. NOTE 1: Not shown on drawings but required by MOBILE COUNTY, your attention is directed to ALDOT, STANDARD SPECIFICATIONS Section 71 8.04(e) regarding the addition of anchor bolt steel alignment templates. NOTE 2: Anchor bolt template will be the same for both the 28 ft. and 37 ft. height poles. NOTE 3: Any known or intended exceptions to these requirements must be made in writing with submittal of bid. Any exceptions shall be stated specifically, with justified reasons. Failure to comply shall justify the removal of the bidder's submittal. 2. Span Wire Clamps Span Wire Clamps (only) shall match attached details for the steel strain traffic pole shown above (see item 1 ) and will include all accessories associated with the assembly. 3. Clamp-on Luminary Steel Truss Arms for Traffic Signal Poles Clamp-on luminary steel truss arms only for traffic signal poles shall match the attached details for the steel strain traffic pole shown above (see item 1 above) and will include all accessories associated with the assembly. 4. Traffic Signal Pole Anchor Bolts Assembly with Alignment Templates Anchor bolts assembly only with alignment templates shall match the same details of the steel strain traffic poles shown above (see item 1 above) and will include all accessories associated with the assembly.