Specifications include, but are not limited to: Warrants must be compatible for use in Xerox 120mx Nuvera Production System laser printer and a Moore LM25 Plus and LM30 speed sealer pressure seal system. Size: Overall size is 8 1/2 " x 14" Composition: Printed front and back A. Face print to be in copyban capture (mt-01-cube) ink335pms. B. Face print to include a hidden word feature and micro or logo line security feature. C. Back print to be in black ink. Paper: 28# pressure seal impregnated with chemical composition adhesives to insure a full perimeter seal of all areas of the out-going documents. Cohesive should not contain styrene chemical. Laser mocr with a custom watermark security feature. Bleed thru numbering security feature where the red or black ink bleeds through red. Must use UV heat resistant inks. Control Numbers: Warrants to have two red ink consecutive control numbers in 1/8" or 3/16" font. One consecutive number will be located on the face of the warrant in the extreme top middle. The other will be located on the envelope centered beneath the wording "see reverse side for opening instructions". Perforation: All to be extraction perforations. Two full length perfs on each side measuring 1 / 2" from each edge. Six full width perforations with each perforation measuring from the top of form to be 1 / 2 " - 4 11 / 16" - 5 5 / 16" - 8 13 / 16" - 9 5 / 16 and 9 13 / 16". Printing Sites: Because of the critical delivery time frames, the successful vendor must have more than one printing plant location for disaster backup purposes. Packing: Warrants to film wrapped with low numbers on top warrants to be stacked on pallets with low number being on the top of stack. Pallets to be 36" x 30" in size to accommodate storage door size. Sample: Sample envelopes must be received with the bid. A sample must be mailed to The Alabama Department of Purchasing in a marked envelop with the Sourcing Project number. Sample must be approved before printing of order
