Specifications include, but are not limited to: 3.1.1 Uni Mac High Performance Industrial Washer Extractor UWT105D4 (or equal). 3.1.1.1 High Performance Washer/ Extractor frame must be strongest-duty structural plate steel frame. 3.1.1.2 High Performance Washer/ Extractor Cabinet construction must: Cabinet front, top, sides and inner and outer tubs, must be 304 grade stainless steel or equal stainless-steel cylinder, tub, and cover panels. 3.1.1.3 High Performance Washer/Extractor must Input Voltage: 208-volt, 3-phase, 60 amp, three (3) wire plus ground. 3.1.1.4 High Performance Washer/Extractor must dry weight capacity must be 105- pounds, minimum but must not exceed110 lb. capacity. 3.1.1.5 Wash cylinder volume must be 15.9 minimum cubic feet. 3.1.1.6 High Performance Washer/Extractor must Overall width must be 40.1 inches but not exceed 44 inches. 3.1.1.7 Overall height must be 67.6 inches, minimum. 3.1.1.8 High Performance Washer/Extractor must Overall depth: 56.2 inches, minimum. 3.1.1.9 High Performance Washer/Extractor must have a minimum of 9 speeds 3.1.2 Uni Mac Industrial 120Lb Tumble Dryer UT120N (or equal) 3.1.2.1 Industrial Tumble Dryer must be of the material: Galvanized Steel: ASTM A 653/A 653M, G90 (Z275) coating designation; commercial -quality, cold rolled steel that is zinc coated by the hot-dip process and chemically treated. 3.1.2.2 Industrial Tumble dryer must be made of Strongest duty embossed steel with electrostatically applied baked enamel finish. 3.1.2.3 Industrial Tumble Dryer must be for Input Voltage: 208-volt, 3-phase, 60 hertz, three (3) wire plus ground. 3.1.2.4 Industrial Tumble Dryer must have a minimum capacity of 120 lbs. and a maximum of 130 lbs. 3.1.2.5Industrial Tumble Dryer must have a Natural Gas heat source, one (1”) inch NTP