Specifications include, but are not limited to: Edge mill 1.5 inch of existing asphalt from face of curb to a distance adequate to provide proper tie-in with in the specified length and according to the location key. b. Milling may be required on streets that are overlay only at driveways, around inlets, etc. c. Place 1.5 inch hot laid bituminous concrete in the above stated areas after the pavement removal is completed. d. Adjust water valve, manholes, and inlets where applicable. The adjustment will be completed by the use of precast iron riser similar to those manufactured by East Jordan or equal. Sealing on the inside of the riser ring will be required for all sanitary manholes. See attached specification, an equivalent product may be used.