Specifications include, but are not limited to: 1.1.1 Rubber Wall Base. 1.1.1.1 The Vendor shall provide and install a four-inch (4”) rubber wall base molding as a component of the installation-using manufacturer recommended methods of preparation and installation; and manufacturer approved adhesives. 1.1.1.2 The Rubber wall base product to be installed in Lower Level Hallways for the Culture Center is: P-191, Rubber Wall Base, OR EQUAL; a product of Roppe Corporation, U.S.A., 1602 North Union Street, Fostoria, Ohio 44830 1.1.1.2.1 Any OR EQUAL product submitted for consideration must meet the specification detailed below: 1.1.1.2.1.1 Toe Style: Standard Cove Toe 1.1.1.2.1.2 Nominal Height: 4” 1.1.1.2.1.3 Nominal Length: 4’ 1.1.1.2.1.4 Nominal Thickness: 1/8” 1.1.1.2.1.5 Material: Thermoplastic Rubber (TPR) Rubber 1.1.1.2.1.6 Color: P-191: CAMEL 1.1.1.2.2 The rubber base product must be installed using manufacturer recommended methods of preparation and installation; and use manufacturer approved adhesives. 1.1.2 Rubber Corner Guard 1.1.2.1 The Vendor shall provide and install a Fifty-Four (54) Inch high rubber Corner Guard molding as a component of the installation-using manufacturer recommended methods of preparation and installation; and manufacturer approved adhesives. 1.1.2.2 The Rubber Corner Guard product to be installed in Lower Level Hallways for the Culture Center is: Rubber Accessories, Rubber, #19-Corner Guard, OR EQUAL; a product of Roppe Corporation, U.S.A., 1602 North Union Street, Fostoria, Ohio 44830 1.1.2.2.1 Nominal Height: 54” 1.1.2.2.2 Nominal Width: 2-3/4” each corner. 1.1.2.2.3 Nominal Thickness: 3/16” 1.1.2.2.4 Color: P-191 CAMEL 1.1.2.3 The rubber corner guard product must be installed using manufacturer recommended methods of preparation and installation; and use manufacturer approved adhesives.