Specifications include, but are not limited to: A. General millwork and custom cabinetry unless specified herein or so noted on plans as included within this section. B. Rubber, vinyl or other finished toe base. C. Blocking with walls. D. Sinks, faucets, fittings, traps, stops, tail pieces, vacuum breakers, and other fixtures, electrical and mechanical runs and connections. ; Pressure Fused Laminate/Interior Surfacing: a. Melamine resin impregnated, 100 gram PSM minimum, surface laminated to core under pressure ; Particleboard cabinet components to be of the following minimum core thickness prior to lamination: a. 3/8” cabinet backs b. 1/2": dividers, as detailed c. 3/4": base and tall cabinet tops and bottoms, cabinet sides, drawer spreaders, door, drawer head, cabinet back rear hangstrips ; a. Casters for low mobile units to be LH-390 4 inch x 1 1/16”. Minimum 275 lb. Load rating per caster. Wheel brakes on front two casters. b. LH-386 swivel casters for standard mobile cabinets shall be plate type caster with ball bearing swivel. ; Run all conduit concealed, except conduit may be run exposed in mechanical rooms, locations where specifically indicated, and spaces with exposed construction as approved by the Architect. B. Provide a conduit system complete with fittings and hangers as specified herein and as required by the NEC. Run all electrical wiring systems in conduit.