Specifications include, but are not limited to: 1. Architectural Services: a. Programming i. Programming Meeting – The architectural consultant will meet with representatives from Alburgh Family Clubhouse and Alburgh School District to discuss and better understand programmatic requirements. A schematic design will be created based on the meeting results and the description of the facility located in Section VII – Child Care Center Description and Programming. ii. Site Assessment and Info Gathering – The architectural consultant will visit the intended Alburgh site. The architectural consultant will take photographs and measurements will be taken of the site. The architectural consultant may also take photographs and basic measurements within the existing elementary school to assess existing mechanical, plumbing, and electrical infrastructure that may be used to help support the new building (if deemed necessary). b. Schematic Design The architectural consultant will produce the following drawings to complete schematic design of the proposed child care facility: i. Overall Floor Plan - The architectural consultant will create a schematic floor plan based upon programming meeting #1. These drawings will include overall dimensions to assist with estimating. ii. Preliminary Code Plan – The architectural consultant will perform a preliminary code analysis/plan for the Vermont Fire and Building Safety Code, Vermont Access Code (ADA), and Vermont Commercial Energy Building Standards (CEBS) to determine improvements necessary to meet current code requirements. Please see the attached State Project Review Sheet. iii. Roof Plan – The architectural consultant will provide an overall roof plan, illustrating drainage, building slopes, and overall scope. iv. Reflected Ceiling Plan – The architectural consultant will provide a preliminary ceiling plan to define lighting, mechanical, and ceiling layouts. v. Exterior Elevations - The architectural consultant will create four exterior elevations based upon cardinal points. Drawing will include dimensions and notes. vi. Overall Building Section – The architectural consultant will provide two building sections cut to identify building height elevations relative to structural systems. vii. Wall Sections – The architectural consultant will create two wall type sections to understand the structural and thermal envelope. viii. Wall Partition Types – The architectural consultant will define basic interior and exterior wall partition types.